Since your password () might contain 'special characters', translate it into ASCII hexacode. The best solution to set a proxy for http/https protocols is via the shell variables http_proxy and https_proxy:Įxport http_proxy= : : export https_proxy= : : In such case, skip the rest of this section and jump to Installing extra packages.Īny other situation likely indicates that a proxy is required for http/https protocols. If an 'OK' message is returned, the network is well configured. Wget -q & echo 'Internet access over HTTP/HTTPS is OK !' || echo 'No internet access over HTTP/HTTPS ! You might need to set up a proxy.' The command below enables checking internet access through http/https protocols: Required at least for Developer Package and Distribution Package.

Internet access through http and https protocols.

ST solutions are tested and validated on a Linux PC running Ubuntu 20.04 LTS (Developer package may not work on Ubuntu 18.04 LTS). Other Ubuntu revisions could also supported (refer to Yocto reference manual ). The table below corresponds to the minimal validated configuration:Ĩ cores/threads or more is a good configuration for Developer Package and Distribution Package.ġ6 Gbytes or more are recommended especially for Virtual machine setup, Developer Package and Distribution Package.ġ Tbytes is the best suited configuration for Distribution PackageĪ Linux PC with recent Ubuntu LTS (22.04, 20.04 or 18.04 with restrictions) is the recommended setup. However ST recommends to meet or exceed the following hardware requirements when using the Developer Package or Distribution Package. There are no absolute minimal requirements regarding the PC hardware configuration. Native + additional packages (see Linux PC chapter ) Tested with Ubuntu ® 22.04, 20.04 and 18.04 (with restrictions) The table below guides through the selection and configuration of the host PC environment according the targeted Package: The PC requirements depend on the Package you want to use. This article explains and describes the host PC hardware and software configuration required to activate and run the STM32 MPU platforms.

4.1.2 Downloading the Ubuntu image for the virtual machine.

3.2.1 Installing extra packages for Android TM.

Vmware player wsl2